
We build, repair, and refinish decks for homeowners around Chicago, most of us came up through framing and general carpentry before deck work became the main focus. You're probably here because something on your current deck is failing, or you're finally ready to use that backyard space the way you pictured it.
If a deck's failing, it's almost always the ledger board, the railing posts, or the footings, pulled loose, wobbling, or heaved by frost. We bolt and flash the ledger properly, run railing posts through with structural screws instead of toe-nails, and set footings below the 42-inch frost line so the deck doesn't shift every spring.
None of this is complicated. It is mostly just doing what we said we would do.
We're licensed to pull deck permits in Chicago and the surrounding suburbs, and we carry liability insurance on every job. Ask for a certificate before we start and we'll send one over.
Most municipalities around Chicago require a permit and a footing inspection before the deck boards go down. We deal with the village or city office directly so the inspection happens on schedule instead of holding up the project.
Deck framing leaves behind cut-offs, sawdust, and dropped fasteners. We sweep the yard with a magnetic roller at the end of each day so nobody steps on a screw barefoot.
Our quotes list the decking brand, the fastener type, and the footing count, not just a lump sum. That way you know exactly what you're paying for before we cut a single board.
We don't hand your project off to a rotating cast of subcontractors. The same crew that sets the posts comes back to install the railings and run the stain.
Frost depth, setback rules, and permit requirements shift from one Chicago suburb to the next. We've built decks under enough of these codes to know what each inspector is going to look for.
Questions about who you'd actually be hiring.
Free estimate, a price in writing, and work we stand behind.